How do I set up policy based routing?

How do I set up policy based routing?

How to Configure PBR (Policy-Based Routing)?

  1. Step1: Configure ACLs. Permit statement in ACL is what will be matched.
  2. Step2: Configure route map instances.
  3. Step3: Configure match commands.
  4. Step4: Configure set commands.
  5. Step5: Configure PBR on the interface.
  6. Step6: (Optional) Configure local PBR.

What is policy based routing Fortigate?

Policy routing enables you to redirect traffic away from a static route. This can be useful if you want to route certain types of network traffic differently. You can use incoming traffic’s protocol, source address or interface, destination address, or port number to determine where to send the traffic.

What is route policy in networking?

A routing policy enables you to control (filter) which routes a routing protocol imports into the routing table and which routes a routing protocol exports from the routing table.

Which is a characteristic of policy-based routing PBR )?

With PBR, a network engineer has the ability to dictate the routing behavior based on a number of different criteria other than destination network, including source or destination network, source or destination address, source or destination port, protocol, packet size, and packet classification among others.

How do I enable policy based routing in FortiGate?

Configuring a policy route

  1. Go to Network > Policy Routes.
  2. Click Create New > Policy Route.
  3. Configure the following fields: Incoming interface. port1. Source Address. 0.0.0.0/0.0.0.0. Destination Address. 0.0.0.0/0.0.0.0. Protocol. TCP. Destination ports. 21 – 21. Type of service. 0x00. Bit Mask. 0x00. Outgoing interface.
  4. Click OK.

What is PBR Fortinet?

The purpose of this article is to describe the Fortinet PBR (Policy Based Routing) behavior by design. The PBR should work with the IP written in the “gateway” label of the policy that represents a general hop, not necessary the next hop, in the network reachable via routing table in the same FortiGate unit.

What is policy-based routing checkpoint?

Policy-Based Routing (PBR) lets the user create routing tables that enable Gaia OS to direct traffic to appropriate destinations by defining a policy to filter the traffic based on one or more of the following: Interface at which a packet arrives. Source IPv4 address and subnet mask.

What is policy based routing and BGP?

The Policy-Based Routing feature is a process whereby a device puts packets through a route map before routing the packets. The route map determines which packets are routed next to which device. Policy-based routing is a more flexible mechanism for routing packets than destination routing.

How do I check my Fortimanager routing table?

The routing tables can be accessed by going to System Settings > Network and clicking Routing Table and IPv6 Routing Table.

How do I set a default route in FortiGate?

Adding a default route.

  1. Go to Network -> Static Routes. Typically,there is only one default route.
  2. Set ‘Destination’ to ‘Subnet’ and leave the destination IP address set to 0.0. 0.0/0.0.
  3. Set Gateway to the IP address provided by the ISP and Interface to the Internet-facing interface.

How do I check my FortiGate routing?

If the FortiGate is running in NAT mode, verify that all desired routes are in the routing table: local subnets, default routes, specific static routes, and dynamic routing protocols. To check the routing table in the web-based manager, use the Routing Monitor by going to Router > Monitor > Routing Monitor.

How do you read a FortiGate routing table?