What front axle is in a 2000 F250?

What front axle is in a 2000 F250?

Dana 60 front axles have been used in FORD F-250 and F-350 4×4 trucks since the mid 70’s. In 2000 Ford F-450 and F-550 4×4 models also used the Dana 60 front axles and starting in 2005 the F-450 and F-550 had the Super 60 front axles.

What front axle is in 99 F250 Super Duty?

Brand. When the 1999 Ford F-250 and F-350 Super Duty® trucks were first introduced, all the Single Rear Wheel (SRW) models used a Dana-Spicer Model 50 monobeam front axle.

Does Ford Super Duty have solid front axle?

The only full-size trucks with a solid front axle are Ram’s heavy-duty lineup and Ford’s Super Duty trucks. Every half-ton truck uses independent front suspension.

What year did Ford stop using solid front axles?

According to ALLDATA, four-wheel-drive Ford half-tons used the TTB setup with coil springs and radius arms from 1980 to 1987. The 1/4- and 1-ton trucks used the TTB with leaf springs from 1980 to 1987 — with the exception of the 1986-1987 F-350 with the Dana 60 (monobeam) solid front axle.

What axle is in a Ford F250?

For the 2017-2019 F-250, the front axles are still a 35 spline Dana 60 axle. In the back, the 10.5” is still standard but trucks fitted with the Heavy Duty Towing Package are set up with a Dana M275 axle.

What trucks have Dana Super 60?

Referred to internally as the “Fat Boy”, the Dana Super 60 evolved from the ’78-’79 Dana 60 front axle first found under Ford F-250 and F-350 trucks.

What axle does my F250 have?

What vehicles came with a Dana 60 front axle?

The Dana/Spicer Model 60 is an automotive axle manufactured by Dana Holding Corporation and used in OEM pickup and limited passenger car applications by Chevrolet, Dodge, Chrysler, Jeep, Ford and Land Rover.

How do I know what front axle I have?

To figure out exactly what axle you have, you can look for the Dana stamped bill of materials number. This stamped number can usually be found on the righthand side or on the longer axletube on the same side of the tube as the differential cover, facing the rear of the truck.

How do I know if I have Super 60?

It can be readily identified by its straight axle tubes, 10 bolt asymmetrical cover, and a “60” cast into the housing.

What trucks use Dana 60?

The Dana 60, a heavier-duty axle than the Dana 44, was first used in the 1950s. It was the axle of choice under countless Dodge, Ford, GM, Studebaker, IH and Jeep 3/4-ton and 1-ton fullsize trucks, as well as Ramchargers and Trail Dusters with the 440ci V-8, and some heavy-duty 1/2-ton Ford and IH trucks.

What Ford trucks came with a Dana 60?

1974–1979 F-250 (optional)

  • 1999–2011 F-250 (optional)
  • 1979, 1986-2011 F-350 (optional)
  • 2000–2004 F-450/F-550.