Why does my Zodiac pool cleaner turn upside down?

Why does my Zodiac pool cleaner turn upside down?

The water level in a pool is one of the most common causes for automatic pool cleaners to flip over. When the water level on the skimmer is too high, the water line is too close to the coping.

Where do I put the weights on my pool cleaner?

For pools 4′ deep or less, use 1 hose weight 4″ to 12″ from the cleaner. For pools of 4-7′ deep, use 2 weights, one 4″ to 12″ from the cleaner and one 6′ from the cleaner. For pools from 8′ to 12′ deep, use a third weight, placed 10 ft. from the swivel end of the cleaner.

Where do I put the weight in my pool cleaner?

Why is my zodiac pool vacuum not moving?

If water is present, check the diaphragm for excessive stretching, rips or tears and check for blockages inside the suction cleaners engine that may prevent water flow. Check the Flow rate/Suction level and the AD valve setting to ensure adequate suction is available.

Why is my pool vacuum not getting enough suction?

When a suction cleaner is sluggish or slow, it’s usually a clogged pump basket or dirty filter that is to blame. Other problems include holes in the cleaner hose, sucking air into the hose, or the filter pump could be drawing in air, reducing water-flow volume.

Where does hose weight go?

To find the correct location for the weight of your faucet, locate the lowest point on the spray hose. The correct location for the weight is between the spray head and the lowest point of the spray hose. Install the weight a few inches above the lowest point of the spray hose.

Why is my zodiac creepy crawly not moving?

If Kreepy Krauly is not moving or not pulsating. Check that the main drain and all suction lines are closed, except for the suction line to which Kreepy Krauly is attached (usually a skimmer). Check for debris in the filter or [pump basket]. Check for debris in Kreepy Krauly flapper.