Table of Contents
How many Cisco AP users are there?
The Access Point can support up to 20 clients (PC) or 7/8 phones comfortably, which depends on the application. The AP has the physical capacity to handle 2048 MAC addresses.
What is embedded wireless controller?
Embedded Wireless Controller (EWC for short) is basically a Catalyst 9800 Wireless Controller running inside the Catalyst 9100 Access Point. The concept is the same as Mobility Express; you load the Controller software on one (or two) APs and then the APs join that controller.
How do I set a default access point?
The access point can be set to factory default by pressing its Reset button or using the access point’s web-based setup page….
- Open the access point’s web-based setup page.
- Click the Administration tab and then click on the Factory Defaults sub-tab.
- Click Restore All Settings.
How many clients can connect to AP?
Ideally, not more than 24 clients can associate with the AP because the throughput of the AP is reduced with each client that associates to the AP.
What is Cisco client Link?
ClientLink is a beamforming capability built into Cisco Aironet® wireless LAN access points. When the access point (AP) concentrates signals toward the receiving client, that client is better able to “hear” the AP’s transmission, so throughput is greater.
What is embedded WLC deployment?
Embedded WLC Deployment This deployment option is a switch with an integrated WLC, and it supports up to 200 APs. The APs don’t have to be physically connected to the switch that hosts the WLC. APs connected to other switches can join the WLC as well.
How do I Reset my cisco AP password?
1. Press and hold the MODE button while you reconnect power to the AP. 2. Hold the MODE button until the Status LED turns amber (approximately one to two seconds), and release the button.
How do I setup a cisco wireless access point?
Obtain the IP address of your Wireless LAN controller from your company’s IT professional. Access the 1810 Series OfficeExtend access point GUI as described in “Accessing the GUI” section on page 2-1. Choose Configuration > WAN tab. Enter the IP address of the primary controller in the Controller IP Address field.
What is maximum clients on SSID?
The limit is 64 connecting to a single AP SSID at 2.4GHz and another 64 connecting to the same AP SSID at 5GHz. You can add a second SSID and have the same max number of clients on that AP’s second SSID as each SSID has its own limit.